基于硅波导的喇曼光放大器

在硅波导上添加反向偏压的PIN结构,当波导产生受激喇曼散射时,可以将波导中双光子吸收(TPA)产生的光生自由载流子扫出波导,降低了波导的非线性损失,极大地提高了硅波导中泵浦光对信号光的喇曼增益。为了应用已经非常成熟的硅工艺,并且应用硅波导使器件小型化,根据法布里-帕罗(F-P)腔和行波放大器理论,在硅波导两端的解理面蒸镀增透膜,应用这种波导的喇曼效应设计了一种光放大器,即基于硅波导的喇曼光放大器。建立了计算放大器增益的方程,给出了不同波导长度和输入功率情况下的放大器增益,得出适当增加波导长度和泵浦光功率可以得到较高喇曼增益的结论。基于硅的光放大器有较高的饱和功率且没有泵浦源的限制,通过调整泵浦激光的波长可以放大不同波长的信号光。     

拉曼放大器中放大的自发拉曼散射与拉曼开-关增益关系的研究

研究了拉曼放大器中放大的自发拉曼散射对拉曼开－关增益的影响，并提出了一种利用自发拉曼散射谱来调整拉曼放大器位曼开－关增益平坦的方法，实验采用4个波长为14xx nm的激光二极管作为抽运源，75km的G．652光纤作为传输介质，获得了C波段附近的光放大，同时对此给出了合理的理论解释。     

考虑到束-波相互作用的速调管离子噪声二维模拟

采用粒子模拟的方法并考虑电子束与电磁波的相互作用，首次直接得到了速调管输出信号的离子噪声图像，阐述了束电子、二次电子、离子、电磁场之间的相互作用的动力学过程. 指出离子噪声所表现出来的相位波动是由电子束速度的波动引起的，电子束速度的变化来源于管内离子数量的变化，离子的数量的变化又与电子束状态变化相互影响，这是离子噪声产生的根本原因. 二次电子对离子噪声产生过程的影响甚微，但是其行为却反映了离子噪声的形成机理. 离子噪声引发的输出信号幅度波动取决于电子束速度和半径的改变，与离子行为密切相关. 关键词： 离子噪声 速调管 粒子模拟 电子束     

All-optical frequency multiplication/recovery based on a semiconductor optical amplifier ring cavity

A novel scheme for all-optical frequency multiplication/recovery based on a semiconductor optical amplifier ring cavity is proposed and investigated numerically. The results show, for a 2.5 GHz driving pulse train, it can be generated 5-25 GHz repetition rate pulse trains with low clock amplitude jitter, polarization independence and high peak power. Furthermore, the extraction of the clock signal from a pseudorandom bit sequence signal can be realized based on the proposed scheme.     

Single to 16-Channel Wavelength Conversion at 10 Gb/s Based on Cross-Gain Modulation of ASE Spectrum in SOA

A simple scheme for single to multi-channel wavelength conversion based on cross-gain modulation of amplified spontaneous emission (ASE) spectrum in semiconductor optical amplifier (SOA) is described. Single to 16-channel wavelength conversion at 10 Gb/s is first demonstrated without any additional probe lights, the modulation information carried by input signal could be converted into arbitrary many channels if only the demultiplexer with enough channels is exploited. Output performance and pattern effects are investigated experimentally.     

高功率LDA紧密侧面抽运Nd:YLF两级双程离轴放大系统实验研究

 介绍了一台10mm口径两级双程离轴放大系统，实现了对5mm×5mm口径光束的激光放大，耦合系统采用高功率LDA紧密侧面直接抽运棒状Nd:YLF方式。分析并实验研究了在不同抽运电流、放大脉冲与放大器LDA抽运时刻的不同延时及不同注入能量条件下，放大系统及光束每次放大时放大特性的规律。实验得到：在放大系统5mm×5mm软光阑处注入1.58mJ能量时，放大系统可输出129.2mJ能量，能量提取效率达到19.5%，满足该系统的设计指标。     

一种新的永久周期磁铁聚焦的高功率宽带放大器

 提出了一种新的高功率宽带放大器，它由速调管和自由电子脉塞组成，用永久周期磁铁聚焦。研究了这种器件的电子束聚焦、群聚和辐射。在速调管提供一阶调制系数为30%，波导管的半径1.51cm，摇摆器的磁场振幅0.16T，周期7.92cm，电子束的电压490kV，电流50A和半径0.368cm的条件下，预估这种器件的辐射波频率为11.4GHz，输出辐射功率为18MW，输出辐射带宽为44%。     

Performance of a CW pumped Nd:YVO4 amplifier with kHz pulses

Until recently, simple and reliable high repetition-rate laser sources with nanosecond pulses much shorter than from conventional A-O Q-switch lasers were not available. However over the past 2 years we have developed such lasers based on proprietary fast E-O switching technology, which allows designs delivering 1 ns pulses and subnanosecond jitter for good synchronisation. The technology provides pulses with multi-kW peak power and repetition-rates to >100 kHz.Most recently, the performance of these short pulse lasers has been developed further by implementing oscillator/amplifier (master oscillator and power amplifier, MOPA) technology which increases the output to >1 W average power. Here we report on a simple model that has been used to predict the performance of the CW pumped Nd:YVO₄ amplifier used in the MOPA laser. The model is based on the well-known expressions for the saturated gain applying to laser pulses, but more usually applied to pulse-excited amplifiers. The model is shown to allow a good interpretation of the amplifier behaviour for kHz pulses and to be a useful tool for predicting the performance of the MOPA laser.     

两段级联掺铒光纤放大器的优化研究

基于Giles模型,研究了980 nm和1480 nm泵浦的两段级联掺铒光纤放大器(EDFA)的设计,得出了掺铒光纤(EDF)的最佳长度和光隔离器的最佳位置随泵浦功率和信号功率的变化关系.比较980 nm和1480 nm泵浦的两段级联EDFA,可以发现,前者的最佳EDF长度短,而光隔离器最佳位置距EDFA输入端远.     

提高微波功率源性能的一种新型控制系统

本控制系统用于抑制大功率速调管输出微波功率宏脉冲平顶波纹,改善电子直线加速器输出束流的品质.控制方法采用微分线性逼近和矩阵算法对系统的输入和输出进行分析,求出代表系统响应的传输矩阵,从而将复杂的激励一响应计算转化为简单的代数运算.实验结果显示出宏脉冲平项波纹得到了有效抑制,说明采用自适应前馈控制来获得平坦的宏脉冲平顶是切实可行的.